EPA Section 608 - Type II

This section explains the requirements needed when working on high pressure equipment. This information must be known and understood in order to answer many questions that are on the Type II test.

EPA Section 608 - Type III

This section explains the requirements needed when working on low pressure equipment. This information must be known and understood in order to answer many questions that are on the Type III test.

Soldering Course

Learn about low and high temp Solders and Flux; how the different solders work together to bond copper, brass, or steel; the difference between plumbing and HVAC solders; and you will learn how to properly use and apply each solder.

Electrical Trouble Shooting

Learn to troubleshoot the electrical components of the HVAC system. You will be shown how to troubleshoot and repair thermostats, relays, circuit boards, capacitors, contactors and compressors. Topics included: Indoor blower motors, condenser fan motors, and grounded compressors.

Heat Pump Course

Learn how the HVAC system operates as a heat pump system. You will be shown how the system runs in reverse and about the reversing valve, extra metering device, outdoor defrost board and sensor, and bi-flow dryer. You will also be shown how the low voltage is wired to operate the heat pump system.

Sealed System & Air Movement

Learn to properly troubleshoot the Sealed System. You will learn how the refrigerant flows and what it’s doing inside the system. You will be shown how to check for the proper refrigerant charge. You will also be shown where all the components of the Sealed System are located, and learn what they do.